This paper provides a general introduction to welding fundamentals (section 2) followed by sections on a few selected welding processes that have had significant developments or improvements over the last few years. The processes that are discussed are friction welding (section 3), hot plate welding (section 4), ultrasonic welding (section 5), laser/IR welding (section 6), RF welding (section 7...

Plates of 3–5 mm in thickness were extracted from an AZ91D ingot and then butt joints of the plates were produced using tungsten inert gas (TIG) welding method. The TIG arc was also used to deposit welding beads on some of the thin plates. No cracking was found in the butt joints. However, hot cracking was always observed to propagate from the heat affected zone (HAZ) under the welding bead int...

Abstract. The Shielded Metal Arc Welding (SMAW) is a typical manual process with many dangerous application for the welder (pipe hot tapping, underwater welding, etc.). The process robotization seems to be great for safety associated with the improvement of weld quality and repeatability. This work presents a methodology developed for real time trajectory generation for the robotic SMAW. In thi...

the effect of welding residual stresses that was created in thin infill plate of steel plate shear wall system during constructional processes was studied in this research. residual stresses in a welded structure is the result of the non-uniform expansion and contraction and plastic deformation of the weld and surrounding base metal due to heating and cooling cycle, during welding process, this...

This article proposes a novel method for analyzing residual stress and deformation in butt welding on 6 mm SUS304 stainless steel plates, using MSC.MARC, a commercial finite element method software, to find the best location for jig fixtures that will minimize welding deformation. Simulation and experimental studies show that a distance of 100 mm between the jig center and the welding bead cent...